The crushed pulp, juice and peel enter the screw Juicer through the feeding hopper. Because the bottom diameter of the screw increases gradually along the direction of the slag outlet and the pitch of the screw decreases gradually, when the material is pushed by the screw, the volume of the spiral cavity is reduced, which forms the squeezing of the material. The rotation direction of screw spindle is clockwise from the direction of feeding hopper to slag trough.
Juicer product introduction:
The juicer is suitable for crushing apple, pineapple and other nuts.
Screw push extrusion;
The process of juicing and dregs of berries, nuts and vegetables can be completed automatically;
The parts in contact with materials are made of high quality stainless steel.
Working principle of juicer:
The crushed pulp, juice and peel enter the screw Juicer through the feeding hopper. Because the bottom diameter of the screw increases gradually along the direction of the slag outlet and the pitch of the screw decreases gradually, when the material is pushed by the screw, the volume of the spiral cavity is reduced, which forms the squeezing of the material. The rotation direction of screw spindle is clockwise from the direction of feeding hopper to slag trough. The raw material is added into the feeding hopper and pressed by the screw. The squeezed juice flows into the juice container at the bottom through the filter screen, and the waste is discharged through the annular gap formed between the screw and the pressure regulating conical part. The size of the gap can be adjusted by the axial movement of the pressure regulating head. It is used for clockwise (when the hand wheel bearing seat is rotated from the slag discharge groove of the equipment to the feed hopper end, the pressure regulating head will be left, and the gap will be reduced, otherwise, the gap will be enlarged.) The slag rate can be changed by changing the size of the voids, that is, adjusting the resistance of slag discharge. However, if the voids are too small, some of the slag particles and juice will be extruded through the filter screen together with the juice under strong extrusion. Although the juice output increases, the quality of the juice is relatively reduced. The size of the gap should be determined according to the specific process requirements of the user. The purpose of automatic separation of juice and residue is achieved.
All parts in contact with materials are made of stainless steel;
The residue juice is separated automatically.